Fix: ESP32 KISS modem becomes permanently unresponsive under TX backpressure

[agessaman]

Problem

On ESP32-S3 boards (Heltec V4, Station G2), the KISS modem would stop responding after a while and stay dead—SetHardware PING (0x17) timed out and the condition survived a host service restart, forcing the pyMC_repeater client into no-radio mode. nRF52 (RAK4361) on identical firmware was unaffected.

Root cause

The ESP32 modem ran over Arduino TinyUSB USBCDC (ARDUINO_USB_MODE=0), which wedges under TX backpressure: USBCDC::write() busy-spins indefinitely while "connected" (its tx_timeout_ms only guards the lock acquire, not the send loop), and RX events post to a 5-deep queue with portMAX_DELAY. Since loop() is single-threaded and the ESP32-S3 has no DTR/RTS→EN reset, nothing recovers it. nRF52 is immune (hardware UART, non-blocking FIFO writes).

Confirmed by a deterministic repro (flood the modem while never reading replies → permanent wedge) and a heartbeat LED that kept blinking while the data path was frozen, isolating the hang to the TinyUSB layer, below app code.

Fix

Switch the ESP32 KISS envs to the ESP32-S3 USB-Serial-JTAG peripheral (HWCDC, ARDUINO_USB_MODE=1), whose write() is bounded (tries/timeout countdown, not an infinite spin) and which posts RX from ISR.

• variants/{heltec_v4,station_g2}/platformio.ini: build_unflags the board default =0, set =1 (a bare -U is reordered after the -D by SCons).
• examples/kiss_modem/: transport-neutral hardening—non-blocking writes that drop a frame instead of stalling loop() when the TX buffer is full, plus setTxTimeoutMs(). A dropped reply is harmless; the host retries.

Validation

• Builds clean for heltec_v4_kiss_modem, Station_G2_kiss_modem, RAK_4631_kiss_modem.
• nm: HWCDC linked, zero TinyUSB symbols.
• On hardware (Heltec V4): the flood that permanently wedged TinyUSB now recovers in a retry or two, which the host's continuous-read + ping-retry handles.

A Wrinkle

ARDUINO_USB_MODE=1 changes the USB descriptor, so the /dev/serial/by-id/ path becomes usb-Espressif_USB_JTAG_serial_debug_unit_<MAC>-if00.

[ripplebiz]

Just wondering if a better approach is to pre-calc the total frame length, then introduce a new method like:
bool canWriteFrame(size_t len);

And for logic to be:
writeFrame( ... ) {
size_t total_len = ... ;
if (!canWriteFrame(total_len)) return; // bail, all or nothing
_serial.write( ... ); ...
}

[ViezeVingertjes]

I was thinking about the same, but looks like those buffers are quite small (like 64 bytes in some cases). Need some sleep first, but its an interesting one to look into.

[disq]

Duplicate of #2645 (identical branch/commit, created twice due to a tooling hiccup). Closing in favor of #2645.

[cwichura]

@disq The #2645 mentioned appears totally different.