I2C Communication

STM32 NUCLEO-C031C6 to Arduino Bare-Metal Implementation

This repository demonstrates a bare-metal C implementation of I2C communication between an STM32 Nucleo-C031C6 (Controller) and Arduino Uno (Peripheral). The Nucleo sends the Arduino a number, and in response, the Arduino returns the number multiplied by 10 if it's between 1 and 4. Otherwise, it just sends a default value. For the Nucleo, STM32's CubeMX is used to configure SWD/debug and clock initialization. All timer, USART, and I2C manipulation are performed via direct memory-mapped register access. Similarly for the Arduino, all I2C parameters are configured using direct memory-mapped register access. The Arduino library is only used to initialize and utilize the serial port.

Wiring

---

⚡ 5V to 3.3V Bi-directional Logic Converter

• Nucleo Side (Low Voltage):
  • 3V3/GND leads connected to LV / GND respectively.
  • SCL (PB8) connected to LV1.
  • SDA (PB9) connected to LV2.
• Arduino Side (High Voltage):
  • 5V/GND leads connected to HV / GND respectively.
  • SCL (PC5) connected to HV1.
  • SDA (PC4) connected to HV2.

---

🔵 STM32 Nucleo Setup

Category	Details
Hardware	NUCLEO-C031C6 (ARM Cortex-M0+)
Debugger	ST-LINK V2-1 (SWD interface)
IDE	STM32CubeIDE 2.0.0
Toolchain	GNU Tools for STM32 (13.3.rel1)
Libraries	STM32 LL, CMSIS STM32C0xx, CMSIS STM32C031xx

How to Run

1. Import: Import the "STM32C031C6_I2C_Controller" sub-folder as an STM32CubeIDE project.
2. Setup (Optional): Review and adjust the error handler logging and error indicator settings within error_check_utilities.h.
3. Build: Select Project > Build Project.
4. Flash: Use the Run or Debug icons.
5. Run:
   • Ensure that the Arduino has been initialized before the Nucleo. Otherwise, reset the Nucleo using the reset button on the board.
   • Open serial terminal and set to 9600 Baud.
   • Observe the controller transmitting a number to the Arduino and receiving a response.

---

🟢 Arduino Uno Setup

Category	Details
Hardware	Arduino Uno R3 (Atmega 328p)
IDE	Visual Studio Code + PlatformIO
Toolchain	avr-gcc, AVR Dude (via PlatformIO)
Libraries	Arduino.h (Used for Serial UART)

How to Run

1. Open Folder: Select File > Open Folder, then select the "Arduino_I2C_Periph" folder.
2. Build: Select PlatformIO: Build.
3. Flash: Select PlatformIO: Upload.
4. Run:
   • Open serial terminal and set to 9600 Baud.
   • Observe the Arduino receiving a number from the controller and transmitting a response.