v121 Re-adding "MagTag" component doesn't work, shows blank screen. IO page gets displayAdded acknowledge.

[tyeth]

While guide writing I readded the screen. Thought I'd done it a few times before, but maybe it'd rebooted between those attempts, or maybe somethings changed / a bug.

1. Add "MagTag" component via new component picker, change nothing.
2. remove after boot animation and status bar finish
3. Add again a few seconds later
4. Display didn't update.
5. Repeat 2-4 indefinitely.

[brentru]

Do you know if this bug happens on all displays, or just the MagTag?

…

On Fri, Dec 19, 2025 at 8:37 AM Tyeth Gundry ***@***.***> wrote: *tyeth* created an issue (adafruit/Adafruit_Wippersnapper_Arduino#852) <#852> While guide writing I readded the screen. Thought I'd done it a few times before, but maybe it'd rebooted, or maybe somethings changed / a bug. 1. Add "MagTag" component via new component picker, change nothing. 2. remove after boot animation and status bar finish 3. Add again a few seconds later 4. Display didn't update. 5. Repeat 2-4 indefinitely. — Reply to this email directly, view it on GitHub <#852>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AACOW7G2BYLW3LQRVCHD3XT4CP5RRAVCNFSM6AAAAACPRLN2LSVHI2DSMVQWIX3LMV43ASLTON2WKOZTG42DONJWG4ZDOMI> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>