IMU Board - Structure standoffs to BOM and drop 2 resistors

[mjstn]

We need to structure 2 each of these things in nylon parts to the IMU board and assemble them onto the board before shipment of IMU boards to customers. All of these are M2.5 black nylon parts

• M2.5 nut
• M2.5x5mm screw
• M2.5 11mm Hex column standoff with threaded shaft

We also must be sure to specify on BOM DNP for R10,R11,R12

All of above to be specified clearly and are just reminders above here

[mjstn]

This is put here because the OLED display goes on top of this board and we have no other better place for this issue.

[mjstn]

Sent email to Helen and Jithin today with the core content being to update BOM as follows

1. R11 and R12 need to be DNP. I manually removed them so best to get them as DNP on the BOM
2. Add quantity 2 of 'Black plastic nylon M2.5 nuts'
3. Add quantity 2 of 'Black plastic nylon M2.5 x 6mm screws
4. Add quantity 2 of 'Black Plastic nylon 12mm Hex Column standoff spacer' (There may be shorter way to say this)